Foppapedretti ECOPASS Manual De Instrucciones página 15

• ENGLISH •
TO INSTALL / USE
IMPORTANT: If baby is less than 6 months old, the harness belts must be inserted through the lower
slots.
WARNING: Never use the crutch strap without the lap belt.
WARNING: The lap belt is provided with 2 side rings to be used for additional belts in compliance with
the standard BS 6684.
ADJUSTING THE FOOTREST (fig. 15)
Press buttons "A" and adjust the footrest in the required position.
ADJUSTING THE BACKREST (fig. 16)
Reclining the backrest : Lift the adjustment lever "A", located on the back of the backrest and recline
the backrest to the position required, release the lever and make sure the backrest has been secured
correctly in place.
Lifting the backrest: Lift the backrest to the required position, without pressing the lever. Make sure the
backrest has been secured correctly in place before use.
WARNING: for babies under 6 months of age, the backrest must be only in the fully reclined, horizontal
position at all times, seat reaward facing.
LOWER BASKET (fig.1 7)
The basket is fixed in the lower part of the frame with press studs, to remove it you need to unhook them.
It is recommended that you empty the basket before closing the stroller.
CAUTION: The maximum transportable weight inside the basket is 3 kg.
CANOPY (fig. 18)
The canopy must be attached on both sides of the stroller, making sure it is securely fixed.
To attach the canopy, slide and hook the plastic clips along the guides which can be found on both sides
of the frame.
ADJUSTING THE CANOPY (fig. 19, fig. 20)
Extend the hood according to requirements to protect baby from the sun.
NOTE: Babies' skin is very delicate. NEVER leave the baby under direct sunlight. Always make sure that
the hood has been adjusted correctly.
FITTING THE BUMPER BAR
Fitting the bumper bar (fig. 21): Line the bumper bar up with the slots and press on both sides. "A"
click indicates that it has been fastened correctly.
Removing the bumper bar (fig. 22): Press button A on both sides of the bumper bar and at the same
time pull to remove it.
Opening the bumper bar on just one side (fig. 22): Press button "A" on one side of the bumper
bar and pull to open it like a gate.
15