Secureguard Clip - Britax HIGHPOINTl MIDPOINT Guia Del Usuario

Britax Child Safety, Inc.
Adjusting Head Restraint Height
The head restraint can be adjusted and locked into different positions� Check the fit with a child
seated in the booster seat� Ensure that the shoulder belt guides are at or just above the child's
shoulder as shown on page 8�
1� Squeeze and hold the head restraint height adjuster to raise or
lower the head restraint�
2� Slide the head restraint up or down to the desired level�
3� Release the adjustment handle, then pull up to ensure the head
restraint has locked into place�
NOTE: Repeat this process until the shoulder belt lies across the
center of the child's chest and is positioned at or just above the
child's shoulder when positioned through the shoulder belt guide.
10

SecureGuard Clip

Britax recommends using the SecureGuard clip to achieve best vehicle
seat belt placement� The SecureGuard clip should hold the lap part of the
vehicle seat belt in place�
The SecureGuard clip should be adjusted to keep the lap part of the vehicle
seat belt positioned low across your child's upper thighs� Ensure the
bottom edge of the SecureGuard clip is level with your child's upper thighs;
however, the clip itself should not press into your child's upper thighs�
IMPORTANT: The lap part of the vehicle seat belt must not rest on the
child's abdomen�
Adjusting the SecureGuard Clip
1� Remove the SecureGuard Clip�
a� Lift up the front of the base cover by removing the elastics
at the front of the base (see page 26)�
b� Locate the SecureGuard retainer clip and rotate the Secure
Guard strap 90 degrees�
c� Slide the SecureGuard retainer clip through the slot and pull
through the opening and away from the base�
HIGHPOINT/MIDPOINT User Guide
11