Lower Anchor System; Lower Connectors - Britax HIGHPOINTl MIDPOINT Guia Del Usuario

Britax Child Safety, Inc.

Lower Anchor System

The lower anchor system helps to
anchor the booster seat into the car
for added stability and safety in the
event of a crash� The lower anchor
system does not restrain your child�
You must use the lap-shoulder belt to
properly secure your child�
The figure at right shows typical
locations for lower anchors in a
vehicle� Check your vehicle owner's
manual to learn if it is equipped
with lower anchors, information
on the lower anchor locations, and
designated seating positions available
for use with this child seat.
14
LOWER ANCHORAGE SYSTEM LOCATIONS
Vehicle Seat
Head Restraint
Lower Anchors
11 in. (27.9 cm)
Lap-Shoulder
Vehicle Seat Belt
Vehicle Seat
Lower Anchors

Lower Connectors

The lower connectors are located in the back of the base� Store the lower connectors in the slots
when not in use�
Removing and Replacing Lower Connectors from Storage Slots
• To remove, press the lower anchor release button on the child's
left side of the booster base, then pull each of the connectors
from the storage slots�
Vehicle Seat
Belt Retractor
• To replace, press the lower connector adjuster button on the
child's left side of the booster base and then pull the lower
connector adjuster strap until the connectors retract into the
base� Ensure the straps are not twisted�
NOTE: The lower connectors may need to be rotated so they
retract into the slots with the bottom side facing down.
HIGHPOINT/MIDPOINT User Guide
15