Cup Holders - Britax HIGHPOINTl MIDPOINT Guia Del Usuario

Britax Child Safety, Inc.
2� Adjust the SecureGuard webbing�
• To Shorten: Feed the webbing through the SecureGuard
retainer clip and pull the end of the SecureGuard webbing
to tighten�
• To Lengthen: Feed the end of the SecureGuard webbing
through the retainer clip and pull the webbing to remove
slack from the SecureGuard retainer clip� Then, move the
SecureGuard clip to the center of the SecureGuard webbing�
NOTE: The lower edge of the SecureGuard clip should be
level with the child's upper thighs once the child has been
secured in the booster seat.
3� Reattach the SecureGuard clip back into the base of the seat by
rotating the retainer clip 90 degrees and inserting it into the slot�
Ensure the SecureGuard strap is not twisted�
12

Cup Holders

Installing the Cup Holders
IMPORTANT: DO NOT use cup holders with hot liquids�
1� Slide the cup holder into the booster base and press down until
a click is heard�
NOTE: The cup holders are labeled inside "L" and "R", from
the position of the child occupant, and can only be installed as
indicated.
Removing the Cup Holders
1� From under the booster base, locate the tab on the bottom of
the cup holder�
2� Pull forward on the tab to disengage the cup holder, then pull
up to remove it from the booster base�
NOTE: Cup holders are dishwasher safe.
NOTE: Cup holders can be removed to allow for side by side
seating positions.
HIGHPOINT/MIDPOINT User Guide
13