Switching On And Using The Pump; Operating Mode; Regulating Modes - DAB E.SWIM 150 Instrucciones De Instalación Y Manual De Mantenimiento

The functions that can be activated on the output contact are described in paragraph 5.4.
To connect to the input and output connector, use only the cable kit. The details of the connector and of
the connection are included in the kit.
Attention: keep the cable for the input and output signals well away from the power and alternate supply
lines (230V and similar), so as to limit disturbances and interference that can alter the signals.
When it is not in use, the connector on the pump must be kept accurately closed, with the cap well
tightened. Only in this way is the necessary resistance to water and damp guaranteed.

3 SWITCHING ON AND USING THE PUMP

3.1 Operating mode

3.1.1 Regulating modes

The following diagram shows the indicative curves of the system's hydraulic performances.
Head H
ft m
E.SWIM - E.PRO 150
20%
ENGLISH
70%
50%
Flow Q
49
100%
85%
US GPM
m /h
3