DAB E.SWIM 150 Instrucciones De Instalación Y Manual De Mantenimiento página 69

SETTINGS
NOTE:
In case of Speed Mode = Priority, speeds X1-X4 are available.
In case of Speed Mode = Combination, speedsX1 is not available.
In case of Start Input = Speeds, X1 is not enabled and the combination 0 0 does not cause the pump to start.
INPUTS
ENGLISH
STOP
Speeds X1-X4 do not have their own associated duration, but are
activated and deactivated according to external input signals.
PARAMETERS
Config
Origin speed
Start Input
Speed Mode
PARAMETERS
IN0-IN4 Type
67
Setting of the speed "0" (STOP),
useful for the connection of a
possible float or safety switch in
OVERRIDE mode
VALUES DESCRIPTION
Disabled External Control Disabled
Enabled External Control enabled and
Timers A-H disabled
Override External Control enabled with
priority over the enabled Timers
A-H
Digital IN Speed determined by the state of
the digital inputs.
0-10 V Speeds determined by 0-10V
analog voltage signal (see chapter
2.5)
4-20mA Speeds determined by 4-20 mA
analog current signal (see chapter
2.5)
X1 The speed X1 set in the "External
Speeds" menu is implemented.
E.ADAPT Speed determined by the status of
the inputs of the "E.ADAPT"
module
IN-0 Starting of the pump is
determined by the status of input
IN-0.
Speed Pump starting determined by the
status of inputs IN1-4. Without
Priority Each input is associated with a
speed (IN1 --> X1; IN2 --> X2;
etc.);
in the case of more than one
enabled input, the one with the
highest number
(IN4>IN3>IN2>IN1) has priority.
Combinations a speed according to table X is
associated with each combination
of inputs IN1 and IN2
IN1 (0) + IN2 (0) --> SPEED (X1)
IN1 (1) + IN2 (0) --> SPEED (X2)
IN1 (0) + IN2 (1) --> SPEED (X3)
IN1 (1) + IN2 (1) --> SPEED (X4)
VALUES DESCRIPTION
NO Normally Open