Removing The Mono Mount Hardware - Invacare Matrx MX1 Manual De Usuario

3.9

Removing the Mono Mount Hardware

1. Open the cushion cover at the bottom of the back cushion (not
shown).
2. Loosen the locking wedge washers A on either side of the rigidizer
bracket B.
3. Slide the back cushion C upward until the mounting rail D is
disengaged from the rigidizer bracket.
4. Loosen the compression bar hardware E to loosen the band clamp
F.
5. Use a hex key G to push out the locking pins H from the rigidizer
bracket.
6. Separate the rigidizer bracket from the band clamp.
Part No. 1176090
C
3
2
A
A
B
13
3 MONO MOUNT
D
4
E
H
6
Invacare® Matrx® MX1
G
5
F