Possible Malfunctions; Technical Data - IKRA IBHS 62 Instrucciones De Manejo

Possible malfunctions

Malfunction
Hedge trimmer does not run
Hedge trimmer cuts with
interruptions
Motor runs, but cutter remains
stationar
Cutter is hot

Technical data

Petrol-Driven Hedge Trimmer IBHS 62
Max. motor power at speed
Capacity
....................................................................................................
Idling speed
..............................................................................................
Ignition system
.........................................................................................
Spark plug
................................................................................................
Fuel tank capacity
...................................................................................
Mixing ratio (petrol/two-stroke oil)
Cutting length
...........................................................................................
Cutting
.......................................................................................................
Weight (tank empty, blade guard removed)
Sound pressure L
pA (acc. to EN ISO 10517)........................................
Sound power level L
WA (acc. to Directive 2000/14/EC)........................
Vibration
(acc. to EN ISO 10517)..............................................................
Technical changes are reserved.
GB | Operating instructions
Possible cause
• No fuel
• Fault in the fuel line
• Petrol filter blocked
• Spark plug defective
• Carburettor defective
• Internal fault
• Internal fault
• On/off switch defective
• Cutter jammed
• Internal fault
• Clutch defective
• Insufficient lubrication -- > Friction
• Insufficient sliding clearance
• Cutter is blunt
..................................................................
.......................................................
...................................
Remedy
• Check the amount of fuel
• Check the fuel line for kinks or
damage
• Clean or replace the petrol filter
• Replace the spark plug
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Remove object
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Oil the cutter
• Adjust the sliding clearance
• Have the cutter sharpened
0,9 kW at 8500 rpm
3
25,4 cm
3400 rpm
Electronic ignition
NHSP L8RTF
0,6 l
40:1
600 mm
up to 27 mm
6,1 kg
91 dB(A)
K = 3 dB
114 dB(A)
K = 3 dB
2
7,5 m/s
K =1,5 m/s
13
2