Using The Plate Warmer; Cycle Status Indicators - Haier ESD400 Manual Del Usuario

To delay the start
1. Close the door.
2. Repeatedly press
display.
When the delay reaches 12 hours, the delay turns off.Press Delay Start again to
select a new number of delay hours.
3. Select a wash cycle and options.
NOTE: To cancel the delay and cycle, press Cancel. To Cancel the delay and
start the cycle immediately, press Delay Start until no hours show in the
display.

USING THE PLATE WARMER

Use the Plate Warmer option to warm serving dishes or dinner plates.
Note: Do not use the option with cycles.
1. Open the door
2. Press
3. Allow 8 minutes to heat the dishware.
CYCLES STATUS INDICATORS
Follow the progress of your dishwasher with the Cycle Status indicators.
Water Heated
Water Heated glows only when the cycle pauses to heat water to a set
temperature. Washing or rinsing continues as water is heated. Once water
reaches the set temperature, the light goes off and the cycle resumes.
Washing
Displayed during prewash and main wash periods.
Turbidity Sensor
Sensor glows during the sensing part of the cycle. Your dishwasher sense soil
level at the end of the Pre-Wash. Washing continues while Sensing occurs.
Rinsing
Displayed during rinse periods.
until you see the desired hours of delay in the
, Plate Warmer glows.
English
22