Reading Custom Mode Data (Custom Mode) - Eclipse CD7100 Manual Del Propietário

Various Settings
Press the [CUSTOM/MENU]
9
[RTN] button
adjustment mode.
ATTENTION
• When playing a music file in USB memory,
sound data cannot be read into the main
unit. Change into another mode and carry it
out again.
• To load data into the main unit, you have to
make a special folder. For detail information
about how to make the folder, refer to the E-
iSERV manuals.
CAUTION
• Do not turn the ignition switch or power
to the main unit ON or OFF (or remove
the front panel of the main unit) while
data reading is in progress. Data
reading will be interrupted and data may
be damaged.
• Only the [VOL] button can be operated
while the system is reading data.
Reading custom mode Data
(Custom Mode)
Values (PEQ, time alignment, cross over value)
adjusted using the custom mode on the web site.
Adjust values following the instructions provided
on the E-iSERV operation procedure screen, and
download the data to a CD-R or USB memory.
Press the [SELECT] (Upper/ Lower)
1
button to select the Custom Mode.
2
Press the [ENTER] button.
The mode will change to Custom
mode.
Insert a CD-R or connect a USB
3
memory containing data.
Press the [SELECT] (Upper/ Lower)
4
button to select ON or OFF.
If there is no custom data, [NO DATA]
will appear.
62
or
to exit sound
Press the [CUSTOM/MENU]
5
[RTN] button
adjustment mode.
ATTENTION
• PEQ, time alignment, and crossover values
cannot be adjusted while the custom mode
is on. To adjust values, turn the custom
mode off.
or
to exit sound