Adjusting The Sound; Subwoofer - JVC KD-ADV8490 Manual De Instrucciones

Adjusting the sound

You can adjust the sound characteristics to your
preference.
• When is shown on the display, you can move
back to the previous screen by pressing number
button 3.
1
2
• For "EQ" setting, see page 39.
3
Adjust the selected setting item.
A
Fad/Bal (Fader/Balance)
1
Press number button 1 (
to the "Fad/Bal" adjustment display.
2
Adjust the speaker output balance by
pressing:
5 ∞
/ : between the front and rear
speakers. [F06 to R06]
4 ¢
/
right speakers. [L6 to R6]
B

Subwoofer

1
Press number button 1 (
to the "Subwoofer" adjustment display.
4
2
Use
the subwoofer.
• Off *: All signals are sent to the
subwoofer.
• 55Hz: Frequencies higher than 55 Hz
are cut off.
• 85Hz: Frequencies higher than 85 Hz
are cut off.
• 120Hz: Frequencies higher than 120 Hz
are cut off.
40
) to move
: between the left and
) to move
¢
/ to select the LPF to
3
Turn the control dial to adjust the
subwoofer output level. [0 to 8]
4
Press number button 1 (
to another setting level.
4 ¢
/
LPF. [–12dB/oct or –24dB/oct]
Control dial: Turn the control dial to select
the subwoofer phase. [0 deg (normal) or
180 deg (reverse)]
* If "Off" is selected in step
adjust the subwoofer phase.
C
Hi Pass (Hi Pass Filter)
Turn the control dial to select the cutoff
frequency to the front/rear speakers. Set this
to match the LPF setting.
• Off: All signals are sent to the front/rear
speakers.
• 62Hz: Frequencies lower than 62 Hz are
cut off.
• 95Hz: Frequencies lower than 95 Hz are
cut off.
• 135Hz: Frequencies lower than 135 Hz are
cut off.
D
Vol Adjust, [–5 to +5]
Turn the control dial to adjust the input level
of each source (except FM).
Adjust to match the input level of the FM
sound level.
• Before making an adjustment, select the
source you want to adjust.
E
Loudness, [Off or On]
Turn the control dial to select "Off" or
"On." When "On" is selected, low and high
frequencies sound are boosted to produce a
well-balanced sound at low volume level.
4
Exit from the setting.
) to move
: select the quality of
2
, you can only