Adjusting The Sound; Storing Your Own Sound Modes; Subwoofer - JVC KD-BT1 Manual De Instrucciones

Adjusting the sound

You can adjust the sound characteristics to your
preference.
• When appears on the display, you can move
back to the previous display by pressing number
button 3.
1
2
• For "EQ" setting, see the following.
3
Adjust the selected setting item.
A
Fad/Bal (Fader/Balance)
1
Press number button 1 (
to the "Fad/Bal" adjustment display.
2
Adjust the speaker output balance by
pressing:
5 ∞
/ : between the front and rear
speakers. [F06 to R06]
4 ¢
/
right speakers. [L06 to R06]
B

Subwoofer

1
Press number button 1 (
to the "Subwoofer" adjustment display.
4 ¢
2
Use /
frequency to the subwoofer.
• 80Hz: Frequencies higher than 80 Hz
are cut off.
• 120Hz: Frequencies higher than 120 Hz
are cut off.
• 160Hz: Frequencies higher than 160 Hz
are cut off.
3
Turn the control dial to adjust the
subwoofer output level. [0 to 8]
C
VolAdjust, [–5 to +5]
Turn the control dial to adjust the input level
of each source (except FM).
Adjust to match the input level of the FM
sound level.
30
All manuals and user guides at all-guides.com
) to move
: between the left and
) to move
to select a cutoff
• Before making an adjustment, select a
source you want to adjust.
D
Loudness, [Off or On]
Turn the control dial to select "Off" or
"On." When "On" is selected, low and high
frequencies sound are boosted to produce a
well-balanced sound at low volume level.
4
Exit from the setting.

Storing your own sound modes

You can adjust the sound modes and store your own
adjustments in memory.
• When appears on the display, you can move
back to the previous display by pressing number
button 3.
1
Follow steps 1 and 2 on the left column.
• In step 2, select "EQ."
2
Select a sound mode.
3
Select a frequency range.
4
Adjust the sound elements of the
selected frequency range.
5 ∞
1
Use / to adjust the level.
2
Press number button 2 (
the control dial to select the frequency.
3
Press number button 2 (
the control dial to select the band width.
To display the rest
), then turn
), then turn