Important Safety Instructions; Safety Conditions - Ingeteam INGECON SUN 10TL Manual De Instalacion Y Uso

Important safety instructions

Important safety instructions
This section describes the safety warnings and the Personal Protective Equipment used in the unit.

Safety conditions

General warnings
DANGER
Opening the door of the housing does not imply there is no voltage inside.
There is a risk of electric shock even after disconnecting all power sources from the system.
Only qualified personnel may open it, following the instructions in this manual.
When the solar array is exposed to light, it supplies DC voltage to the inverter.
CAUTION
The operations described in this manual may be performed only by qualified personnel.
The status of qualified personnel referred to in this manual will be, as a minimum, that which meets all the
standards, regulations and laws regarding safety applicable to the tasks of installing and operating this unit.
All applicable safety-related legislation for electrical work must be complied with. Danger of electric shock.
Compliance with the safety instructions set out in this manual or in the suggested legislation does not imply
exemption from other specific standards for the installation, place, country or other circumstances that affect
the inverter.
The entire manual must be read and understood in full prior to manipulating, installing or operating the unit.
Following is a list of the basic obligatory safety standards for each country:
• RD 614/2001 in Spain.
• CEI 11-27 in Italy.
• DIN VDE 0105-100 and DIN VDE 1000-10 in Germany.
• UTE C18-510 in France.
Carry out all operations and handling without voltage.
As a minimum security measure in this operation, you must always follow the so-called 5 golden rules:
1. Disconnect.
2. Prevent any possible feedback.
3. Check there is no voltage.
4. Ground and short circuit.
5. Protect from live elements, if any, and put up safety signs around the work zone.
Until these five steps are completed, the work area cannot be considered voltage-free and any work performed
will be considered to be work on live equipment.
Category III-1000-Volt measuring instruments must be used for checking for the absence of voltage.
Ingeteam accepts no liability for any damages caused by improper use of the unit. You must propose in advance
to Ingeteam any work carried out on any equipment which implies a modification of the original electrical
arrangements. These must be studied and approved by Ingeteam.
ABO2011IQM01_A - Installation and Operation Manual
Ingeteam
DE
EN
ES
FR
IT
PT
77