Phase III – Remodeling Phase:
1) Unfasten and remove the stabilisation strap (see fig. 15).
2) The orthosis is worn without the stabilisation strap and foot shell in this
phase.
3) Optional: Refasten the stabilisation strap as described in phase 1.
5.3 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
Textile component:
1) Remove the foot shell from the orthosis.
2) Close all hook and loop closures.
3) Wash the orthosis in warm water at 30 °C with standard mild detergent.
Rinse thoroughly.
4) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight,
stove or radiator).
Foot shell:
1) If necessary, wipe down the foot shell excluding the hook and loop clos
ures with a moist, lint-free cloth and neutral soap.
2) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight,
stove or radiator).
6 Disposal
Dispose of the product in accordance with national regulations.
7 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
7.1 Local Legal Information
Legal information that applies exclusively to specific countries is written in
the official language of the respective country of use after this chapter.
7.2 Liability
The manufacturer will only assume liability if the product is used in accord
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregarding the
17