Filter Mode - Pentair IntelliFlo WhisperFlo VF Guide D’installation

19
Vacuum Mode (Continued)
3. Use the Up and Down arrow buttons to view the screens below:
• REMAINING TIME: Displays time remaining in programmed duration
• POWER (Watts): Displays power to the motor shaft in continuous watts
• ACTUAL SPEED (RPM): Displays pump speed in RPM
• FLOW (m

Filter Mode

IntelliFlo uses Filter Mode to perform the routine circulation of water through the pool's filter. At a press
of the Filter button, IntelliFlo will calculate the flow rate necessary to achieve the desired rate of turnover,
based on the parameters entered for Filter Mode in the Filter Settings Menu, and will control the pump
speed to maintain constant flow during that period.
detailed information on Filter Mode setup.
1. Ensure that the green power LED is on.
2. Press the Filter button. Press the Start/Stop button. "FILTER" will appear in the top left corner
of the display, indicating that the pump is in Filter Mode.
3. Use the Up and Down arrow buttons to view the screens below:
• POWER (Watts): Displays power to the motor shaft in continuous watts
• ACTUAL SPEED (RPM): Displays pump speed in RPM
• FLOW (m
• Filter Status OK (%): Displays, in percent, the degree to which the internal pressure
of the pool filter is approaching "Clean Filter Pressure."
Pressure" on page 26, and "Clean Filter Pressure Example" on page 30
information on Clean Filter Pressure.
IntelliFlo VF Installation and User's Guide
/h): Displays flow
3
® ®
VACUUM 12:15 VACUUM 12:15
23.W
1.MIN
REMAINING TIME POWER
RUNNING RUNNING
/h): Displays flow
3
FILTER 12:15 FILTER
1560.RPM
15.W
POWER ACTUAL.SPEED
RUNNING RUNNING
® ®
VACUUM 12:15 VACUUM 12:15
1545.RPM 16m³/h
ACTUAL SPEED FLOW
RUNNING RUNNING
See "Filter Settings Menu" on page 26
12:15 FILTER 12:15 FILTER
14m³/h 62.0%
FLOW Filter Status OK
RUNNING RUNNING
for more
See "To set the Clean Filter
for more
12:15