Time And Contrast Menu; Setting System Time - Pentair IntelliFlo WhisperFlo VF Guide D’installation

33

Time and Contrast Menu

Use the "Time/Contr" menu to set the IntelliFlo system clock and to adjust the contrast of the control
panel display. The IntelliFlo system clock controls all scheduled start and stop times, functions, and
programmed cycles. The system clock can store the correct time for up to 96 hours after power is shut off.
After 96 hours, the clock must be reset to the correct time.

Setting System Time

To access the Time and Contrast menu:
1. Ensure that the green power LED is on and the pump is
stopped.
2. Press the Menu button. "Pool Data" is displayed.
3. Use the Up and Down arrow buttons to find the " "Time/
Contr" menu item. Press the Select button to select it. "Set
Time" is displayed.
a) To set the system clock:
select the Set Time setting.
b) To set the LCD backlight contrast of the control
panel display:
to scroll to the "Contrast Level" setting. Press the
Select button to select it (Default 5).
4. To change the setting, press the Left and Right arrow
buttons to select which digit to modify, then use the Up and
Down arrow buttons to change the selected digit
When setting the system clock, note that, if the "Time" unit
is set to AM/PM in Units Mode, the system clock will read
01 to 11 for both A.M. and P.M. The letters "A.M." and
"P.M." are not displayed.
The Contrast Level parameter can be set from 0 to 9. Avoid
using 0 unless screen is unreadable in bright sun
5. Press the Enter button to save the setting.
IntelliFlo VF Installation and User's Guide
Press the Select button to
Use the Up and Down arrow buttons
®
Time/Contr
MENU 12:15
Time/Contr
Set Time
®
Time/Contr 12:15 Time/Contr
5
Contrast Level Contrast Level
®
12:15
12:29
®
12:15
7