Pentair IntelliFlo WhisperFlo VF Guide D’installation página 30

28
Filter Menu (Continued)
d) To set the Start and Stop times of Cycles 1 through 4:
buttons to find the "Start Cycle 1" setting. Press the Select button to select it. 9:00 is the
default setting. Press Enter to set 9:00 as the start time. To change the setting, see step 4
below. Use the Down arrow button to scroll down to the "Stop Cycle 1" setting. Press the
Select button to select it. 21:00 is the default setting. Press Enter to set 21:00 as the stop time.
To change the setting, see step 4 below.
4. To change the setting, press the Left and Right arrows to select which digit to modify, then use the
Up and Down arrows to change the selected digit.
5. When you are done, press the Enter button to save the changes. To cancel any changes, press the
Escape button to exit edit mode without saving.
The following example shows the IntelliFlo Control Panel with the Cycle 1 start time programmed
for 9:00, and the Cycle 1 stop time programmed for 21:00. The default of one (1) is entered in
the "Cycles Per Day" parameter. Note that, as long as one (1) cycle is entered in the "Cycles Per
Day" setting, only one of the four available cycles will read "Enabled" on the IntelliFlo Operator
Control Panel. See Filter Cycle Settings table on the following page.
®
Filter 12:15
9:00
Start Cycle 1
Enabled
On the next example, the IntelliFlo Control Panel shows a Cycle 1 Start time of 8:00 and a Cycle
1 Stop time of 10:00, indicating a cycle of 2 hours. Note that the Cycle 2 (Start time of 10:15)
reads "Enabled" because two (2) cycles are entered in the number of Cycles Per Day setting.
Note: IntelliFlo will not allow you to enter overlapping cycle times.
®
Filter 12:15
08:00
Start Cycle 1
Enabled
IntelliFlo VF Installation and User's Guide
®
Cycle 1 Start and Stop
Filter 12:15
time are displayed
21:00
Stop Cycle 1
"Enabled" is displayed
Enabled
because one (1) cycle is
selected in the number of
Cycles Per Day setting
In this example, the
®
Cycle 1 Start and Stop
Filter 12:15
10:00
times are set to run the
Stop Cycle 1
pump for 2 hours.
Enabled
Use the Up and Down arrow
®
Cycle 2 Start time is
Filter 12:15
displayed
21:10
Start Cycle 2
"Disabled" is displayed
Disabled
because only one (1) cycle
is selected in the Cycles Per
Day setting. These screens
will still display even if they
are not enabled.
Cycle 2 Start time is
®
displayed
Filter 12:15
10:15
"Enabled" is displayed
Start Cycle 2
because two (2) cycles are
Enabled
selected in the Cycles Per
Day setting.
®
Filter 12:15
1
Cycles Per Day
®
Filter 12:15
2
Cycles Per Day