Jacuzzi LUXURY Serie Instrucciones De Instalación Y Operación página 14

Drop-in Installation (con't)
Install the unit, inserting the motor/pump end first,
8
lowering the bathtub into the opening as shown in
the illustration (Figure 10).
DO NOT use plumbing fixtures or lines to lower the
unit. Allow the bathtub to rest on the supports.
Inspect all fittings, plumbing, and control lines
9
after inserting to insure the components are not
damaged, disconnected, or contacting the finish
surface substrate or support members.
Connect flex water supply lines to faucet and plug
10
power cords into GFCI outlets.
Remove scrap lumber and lower the bathtub fully
11
into the opening (Figures 11 and 12).
Align the bathtub and connect the drain.
12
Turn on the power supply to the dedicated GFCI
13
protected circuits and check system operation.
Caulk around the perimeter of bathtub to seal the
14
space between the rim and the finished deck.
Page 14
Level Subfloor
Level Subfloor
Uneven
Subfloor
www.jacuzzi.com
Luxury Whirlpool Bath
Scrap Lumber
Maximum 2˝
(50mm)
Thickness Substrate
Member Support
Figure 10
Figure 11
Figure 12
Installation and Operation
Tile or
Finished
Surface
Floating
Floor
Compound