Maintenance And Cleaning - Oase Water Trio Instrucciones De Uso

Ocultar thumbs Ver también para Water Trio:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
- GB -
Pos: 75 /Alle Produkte/Überschriften/H1 Bedienung @ 7\mod_1196625148604_121.doc @ 41443
Operation
Pos: 76 /Lampen/Wasserspieltechnik/Water-Trio/Quintet/Bedienung Water Trio/Quintet @ 8\mod_1219739024353_121.doc @ 51023
Pos: 77 /Lampen/Wasserspieltechnik/Water-Trio/Quintet/Handsender einlernen und löschen Water Trio/Quintet @ 8\mod_1220012940921_121.doc @ 51383
The manual transmitter as part of our scope of delivery is taught in for the 12 V control box. The 12 V control box has
to be adapted to every further manual transmitter.
Teaching-in manual transmitter (J):
The receiver is equipped with a teach-in button (24) to adapt the 12 V control box to the transmission signal of the
manual transmitter.
− Insert a pin (23) into the opening for the teach-in button (24) until you feel a resistance. Keep pressing in the pin (23)
until this resistance is overcome. The teach-in button (24) is then activated.
− Actuate the teach-in button (24) using the pin (23) for approx. 1 sec.
− Press any button of the manual transmitter for at least 1 sec.
Deleting the manual transmitter (J):
− Actuate the teach-in button (24) using a pin (23) for at least 5 sec.
This deletes all manual transmitters stored in the receiver.
Note: A maximum of 10 manual transmitters can be set to the receiver. The manual transmitter has a maximum range
of 80 m. Obstacles between transmitter and receiver, a low battery in the manual transmitter, or electro-magnetic
radiation of electrical equipment will impair the range.
Pos: 78 /Lampen/Wasserspieltechnik/Water-Trio/Quintet/Ausrichten Düsen Water Trio/Quintet @ 8\mod_1219935402024_121.doc @ 51269
Aligning the water jet (K):
− Adjust the individual movable nozzles to align the water jet (5).
Pos: 79 /Alle Produkte/Überschriften/H1 Reinigung und Wartung @ 7\mod_1196625212761_121.doc @ 41469

Maintenance and cleaning

Pos: 80 /Lampen/Wasserspieltechnik/Water-Trio/Quintet/Reinigung und Wartung Water Trio/Quintet @ 8\mod_1219738866712_121.doc @ 50971
Disconnect the power plugs of all other units in the water prior to starting work on the unit (I)!
Cleaning the unit (L, M, N):
− To open, release the nozzle holders (9) by slightly turning it at the housing top section (10) and remove.
− Unscrew the LED light nozzles (11) and, if fitted, the extension tubes (6) (see Fig. C).
− Laterally slide the respective pump (26) out of the engagement holder of the filter basket (27).
− Slightly turn the pump cover to disengage (28), then remove the impeller (29).
− Clean all components under running water using a brush.
Reassembling the unit:
Reassemble the unit in the reverse order (L, M, N).
Note: Push the pump housing into the filter basket until it tangibly engages.
Pos: 81 /Alle Produkte/Dummy_module/===== Seitenwechsel ===== @ 0\mod_1125648978015_0.doc @ 1630
14
The manual transmitter can be used to select 9 programmed water feature patterns.
Program 1 appears automatically when starting up and with each new start of the unit.
P0
Unit off, stand-by mode
P1
All fountains active, fixed height up to max. 30 cm
Light on for all fountains
P2
All fountains active, fixed height up to max. 70 cm
Light on for all fountains
P3
All fountains active, dynamic fountain height, max. 70 cm high
Light on for all fountains
P4
One fountain each alternatingly active in intervals, max. 70 cm high
Light switched on for each active fountain
P5
All fountains active, fixed height up to max. 110 cm
Light on for all fountains
P6
All fountains active, dynamic fountain height, max. 110 cm high
Light on for all fountains
P7
One fountain each alternatingly active in intervals, max. 140 cm high
Light switched on for each active fountain
P8
All fountains active, dynamic fountain height, max. 140 cm high
Light on for all fountains
P9
Several fountains alternatingly active, max. 140 cm high
Light switched on for the respective active fountains
Select next program: Button 1
Select previous program: Button 2
Note:
− Program 1 always starts when Water Trio / Water Quintet is switched on by a timer.
− Fountain heights can be varied.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Water quintet

Tabla de contenido