2.2 Safety information on electromagnetic
compatibility
WARNING!
Risk of malfunction due to electromagnetic
interference
Electromagnetic interference between this
product and other electrical equipment can occur
and disturb the electrical adjustment functions
of this product. To prevent, reduce or eliminate
such electromagnetic interference:
– Only use original cables, accessories and spare
parts, to not increase electromagnetic emission
or reduce electromagnetic immunity of this
product.
– Do not use portable radio frequency (RF)
communications equipment closer than 30 cm
to any part of this product (including cables).
– Do not use this product near active
high-frequency surgical equipment and the
RF shielded room of a system for magnetic
resonance imaging, where the intensity of
electromagnetic disturbances is high.
– If disturbances occur, increase the distance
between this product and the other equipment
or switch it off.
– Refer to the detailed information and follow
the guidance in chapter 10 Electromagnetic
compatibility (EMC), page 26.
1574470-D
WARNING!
Risk of malfunction
Electromagnetic interference may cause improper
operation.
– Do not use this product adjacent to or stacked
with other electrical equipment. If such
use is necessary this product and the other
equipment must be closely observed to verify
that they are operating normally.
We are not aware of any risk when using products
like a cardiac pacemaker.
2.3 Labels and symbols on the product
Identification label
The identification label contains important information:
M
L
K
J
I
H
G
Safety
A
B
C
D
E
F
7