Usb Connection - Corghi ProLine Truck 150 Manual De Uso

Picture 9a: Key example showing the main and secondary function
Key secondary function.
This section contains only a
graphic indication. An LED
indicates when the secondary
function is active.
To enter the secondary function of a key, hold the key [P7]
of the keys for which a secondary function is desired, then release both keys.
Table T2: Settings, programs and menus available in SERVICE mode
Key Setting/Program or Menu
[P1] Sensors calibration programs
[P2] ALU Application position for adhesive
weights
[P3] Machine calibration
[P4] Grams/ounces selection
[P5] Inches/mm selection
[P6] Imbalance threshold view selection
[P9] Automatic position search (RPA)
Note: The [P7]
access settings, programs or Menus.
On request, the machine can be set up by the manufacturer to operate with the power
supply available in the place of installation. The set-up data for each machine are given
on the machine data plate and on a special label attached to the power supply connection
cable.
WARNING
Any operations for connection to the workshop electrical board must be carried out
only by qualified technicians in compliance with applicable legislation, under the
responsibility and at the expense of the customer.
80
SERVICE mode
, [P8] Start

USB CONNECTION

Key first function.
This is the sensitive part
that must be pressed.
Key Setting/Program or Menu
[F+P1] Not used
[F+P2] Select weight material in Fe/Zn or Pb
[F+P3] Exit SERVICE mode (go back to NORMAL
mode)
[F+P4] Read counter with the number of spins
[F+P5] Parameters (Menu with password reserved
for technical service)
[F+P6] Not used
[F+P9] Test programs
and [P10] Stop
User manual ProLine Truck 150
down and press one
keys are not used to