Corghi ProLine Truck 150 Manual De Uso página 94

9. Press [P3] once
(internal plane diameter) and within
about 1.5 seconds press [P4]
or [P5]
obtained with one of the two methods
specified in the below note. If neither
of these two buttons is pressed in this
time limit, the machine will return to
the previous display. In this case, you
can press the [P3] key again
to enter or edit the data.
10.Press [P3] twice in quick succession
to view d-2 (external plane
diameter) and within about 1.5 seconds
press [P4]
to enter the value obtained with one of
the two methods specified in the below
note. If neither of these two buttons is
pressed in this time limit, the machine
will return to the previous display. In
this case, you can press [P3]
twice in rapid sequence to enter or edit
the data.
94
to view d-1
to enter the value
or [P5]
Fig.14: Manual acquisition of wheel
distance in ALU 2P Program Type
Fig.15: Manual acquisition of the internal
plane distance in ALU 1P Program Type
Fig.16: Manual acquisition of the external
plane distance in ALU 2P and ALU 1P
Program Types
NOTE: The nominal wheel diameter does
not match the diameters where the weights
are actually applied. Two methods are
possible to determine diameters d-1 and
d-2 to be entered into points 9) and 10)
of the procedure.
User manual ProLine Truck 150
14
15
16