Ordinary Maintenance - Corghi ProLine Truck 150 Manual De Uso

Signalling
Three decimal
Imbalance exceeds
points lit on one
999 grams.
or both displays
• Flashing green The machine is in
STAND-BY LED STAND-BY mode.
a) A user action is
required.
The left (or right)
b) The diameter
display is flashing.
sensor is not
calibrated.
The internal
The internal
sensor has been
sensor disabling
temporarily
LED is flashing
disabled.

ORDINARY MAINTENANCE

WARNING
The company is not to be held responsible for any claims deriving from the use of
non-original spare parts or accessories.
WARNING
Unplug the machine from the power supply and make sure that all moving parts have
been locked before performing any adjustment or maintenance operation.
Do not remove or modify any part of the machine (except for service interventions).
CAUTION
Keep the work area clean.
Never use compressed air and/or jets of water to remove dirt or debris from the
equipment.
During the cleaning procedure, operate so as to prevent, when possible, dust from
forming or raising.
User manual ProLine Truck 150
Table T13: Special visual signals
Meaning
This signal can be caused by:
• No machine calibration.
• Incorrect measures of the wheel size.
• Incorrect setting of the Wheel Type.
• Incorrect setting of the Program Type.
All LEDs and displays are switched off. To exit
STAND-BY mode, press any button (except [P7]
a) The user's action may be pressing a key to
confirm or continue the procedure in progress, or
the selection of a value or a menu option.
b) Call the technical support to carry on with the
calibration of the diameter sensor. To continue with the
operation, you can temporarily disable the sensors by
pressing [F+P2] keys
Sensor disabling will last until the machine is
turned off.
Notes
).
+
.
UK
129