Automatic Position Search (Rpa) - Corghi ProLine Truck 150 Manual De Uso

Automatic position search (RPA)

The machine is capable of automatically stopping the wheel at the first imbalance angular
position that is reached during rotation. This allows the operator to have the wheel in
position ready for the application of the balancing weight thus increasing work and
productivity speeds.
Within this manual, this acronym will be used to refer to the wheel stop procedure on
the positions of imbalance.
The RPA procedure has three different operating modes indicated in table T6.
RPA mode when it can be
At the end of
Automatic
every spin.
At the end of the
spin, when the
Low speed wheel is stopped
and the wheel
guard is raised.
At the end of the
spin, when the
wheel is stopped
Low speed
and the wheel
guard is NOT
present.
At the end of the
spin by manually
Manual rotating the wheel
with wheel guard
raised.
User manual ProLine Truck 150
Table T6: Types of RPA procedures available
When it is or Who can
run the RPA
run procedure
Machine
Operator
Operator
Operator
Notes
This is performed only if there
is at least one imbalance
value on the wheel. Otherwise,
conventional braking will occur.
The procedure is started up
by pressing [P8]
wheel starts up at low speed until
it reaches the first imbalance
angular position.
The procedure is started up by
pressing [P9+P8]
: the wheel starts up at
low speed until it reaches the first
imbalance angular position.
When the wheel is in an angular
position of imbalance, press
[P9] : the locking is
activated or 30 seconds.
: the
UK
111