Corghi ProLine Truck 150 Manual De Uso página 99

When the required selections/settings have been made it is possible to run a spin cycle
by pressing [P8] Start .
At the end of the spin, the machine displays the wheel imbalance values.
Apply the weights displayed by the machine in the indicated positions, and then run a
second test spin. Normally, weights should be applied at 12 o'clock, with the exception of
special programs for ALU 1P and ALU 2P aluminium.
Temporary diameter and distance sensor disabling
If the machine displays the error code Err 016 "dis out" (Distance/Diameter sensor not in
the rest position) at switching on, although being in rest position, it means that an anomaly
occurred in the acquisition system.
It is possible to temporarily disable the Diameter/Distance sensor by pressing keys [F+P2]
+ . The LED on the control board will light up and flash
indicating the automatic acquisition of Diameter/Distance is disabled and the machine is
ready to be used.
As it is not possible to use the automatic acquisition system, the wheel dimensions must
be entered manually.
By turning the machine off and then on again, the Diameter/distance sensor is enabled
again; if the error code Err 016 is shown again, repeat the above procedure.
Wheel Type
UK
The machine allows choosing between three different Wheel Types as listed in table T4.
Table T4: Wheel Types to select
Wheel Type Vehicle Notes
CAR
Cars
TRUCK
Trucks Default at power-on
User manual ProLine Truck 150 99