Acoustic Signals - Corghi ProLine Truck 150 Manual De Uso

OPERATOR ACTION
The machine exits from the error code display when the operator performs an action
linked to said error code (for example, ERR 016, brings the Distance sensor back to the
rest position).
ONCE
The machine displays the error code and its brief description just once, then it returns to
the previous status.
PERMANENT
The machine permanently displays this error code until being turned off, therefore the
error code cannot be exited.
The machine emits different acoustic signals based on its status. The acoustic signals are
listed in table T12.
Signalling
Selecting a program or a
Short beep
function
Long beep
Acquisition.
Long beep +
1 Short beep
Long beep +
2 Short beeps
Double beep Warning.
Triple beep Function not available or Error.
Storing one or more values
Short Beep +
in the permanent memory
Long beep
(eeprom) of the circuit board.
Intermittent
Adjustment.
beep
The acoustic signal is also heard for about two seconds at machine start-up allowing the
operator to check the operation of the alarm (buzzer).
The machine gives special visual signals in certain cases. The special visual signals are
listed in table T13.
128

Acoustic signals

Table T12: Acoustic signals
Meaning
Special visual signals
Notes
• Acquisition of a value.
• Wheel dimension acquisition in DYN Type
programs.
Acquisition of internal plane in ALU 1P and ALU
2P Program Types.
Acquisition of external plane in ALU 1P and ALU
2P Program Types.
A particular condition has occurred that
requires the operator's attention.
The requested function is not available or an
error condition has occurred.
One or more values have been stored in the
permanent memory of the circuit board (for
example, at completion of calibration phases).
Signal used in some service programs to
simplify sensors adjustment.
User manual ProLine Truck 150