Machine Description; Installation - Schneider Airsystems AM 2-10 F1 Micro Manual De Instrucciones

GB

MACHINE DESCRIPTION

TA
3
13
12
1
2
1) Electrical equipment
2) Front panel / Oil indicator level
3) Lid
4) Electric fan
5) Oil filter
6) Oil separator filter
7) Minimum pressure valve
UNPACKING AND HANDLING THE MACHINE
When delivered, compressor top is protected by cardboard packing.
Wear suitable protective gloves and then cut outer straps and then remove cardboard from the top. Check the (outer) good
condition of the machine before moving the compressor. Visually check that no parts are damaged. Also ensure that all
accessories are available.
Lift the machine using a fork lift truck. Fit the anti-vibration elements into their proper seat and move the machine to the room
chosen for its location with maximum care.
Keep all packing materials at least for the warranty period for possible moving. In case of need, it will be safer for delivery
to the technical assistance dept.
Then, dispose of packing materials in compliance with current laws.
LOCATION (fig. 2)
The room chosen for the installation of the compressor should
meet the following requirements and comply with what is specified
in the current safety and accident prevention regulations:
low percentage of fine dust,
•
proper room ventilation and size that allow room temperature
•
under 45°C. In the event of inadequate hot air discharge, fit the exhaust
fans as high as possible.
Exhaust flow rate "2000 m
Exhaust flow rate "4000 m
Condensate should be collected either into a pit or a tank.
The dimensions of the spaces are indicative only but it is advisable
to follow them as closely as possible.
6 6 6 6 6
Rotar Micro - Cod.197CC2300 - Rev.01 - 07/2008

INSTALLATION

/hr" part no. 020041000
3
hr" part no. 020042000
3/
4
5
6
7
8
14
8) Oil separator tank
9) Air filter / Intake regulator / Screw compressor
10) Oil radiator
11) Electric motor
12) SE control panel
13) TA control panel
14) Air intake outlet
1
9
10
11
2