Setting The Drilling Depth (Fig. C); Drilling Holes (Fig. D) - Parkside PSVH 56 A1 Instrucciones De Uso

Setting the drilling depth (Fig. C)

♦ Push the drilling jig
on a flat surface.
♦ Place the step drill
the step drill symbol. The tip of the step drill should contact the tip of
the step drill symbol.
♦ Push the depth stop
drilling jig
♦ Screw the depth stop

Drilling holes (Fig. D)

NOTE
► To provide a stable hold, drill two woodscrews
♦ Clamp the step drill
or a cordless screwdriver.
♦ Press the limit stop on the drilling jig
♦ Place the limit stop on the drilling jig
piece.
♦ Fix the drilling jig
the clamp
♦ Drill into the wooden workpiece as far as the depth stop
│ GB │ MT
■ 26
limit stop upwards and place the drilling jig
right up against the side of the drilling jig with
onto the step drill
.
tight using the hex key
(with the depth stop
and the wooden workpiece firmly in place with
.
as far as the edge of the
.
into each joint.
screwed on) into a drill
downwards.
against the wooden work-
.
PSVH 56 A1