Correct Use; Unpacking; Drive; Motor Protection - IKA EUROSTAR 200 control Instrucciones De Manejo

• Use
For mixing/stirring liquids with low and high viscosities by vari-
ous stirring tools.
Intended use: Stand device (chuck points down).
• Range of use (indoor use only)
- Laboratories
- Pharmacies
• Wireless remote control
Before using the wireless link between the Wireless Controller
(WiCo) and the laboratory device, first check whether your re-
gion is included in the radio communications approval for the
device. If it is not, remote control can also be performed using
a USB cable.

• Unpacking

- Please unpack the device carefully
- In the case of any damage a detailed report must be sent im-
mediately (post, rail or forwarder).
• Delivery scope
- EUROSTAR 200 control or EUROSTAR 200 P4 control
stirrer with a Wireless Controller (WiCo) of the type ordered
- An operating instructions
- An extension arm
- A hexagonal socket screw
- A hexagon socket offset screw key
- A chuck key
- A warranty card
- A decontamination clearance certificate
- OS 1.0 power supply unit
- USB cable micro A – micro B 2.0
- USB cable A – micro B 2.0.
The rotary knob (B, see Fig. 1) of the Wireless Controller (WiCo)
allows the speed of the stirrer to be adjusted over the entire speed
range.
The stirring instrument is suitable for continuous operation. The
motor current is limited electronically. The instrument has an anti-
stall and anti-overload system.
Speed - regulated (no variation in speed)
The speed is monitored and regulated by processor controlled.
The target speed is constantly compared with the actual rota-
tion speed value of the output shaft and variations corrected. This
guarantees a constant speed even if the viscosity of the substance
being stirred changes.
- Schools
- Universities

Motor protection

Speed – normal operation

Correct use

This instrument is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply net-
work that also supplies residential areas.
The safety of the user cannot be guaranteed:
- If the instrument is operated with accessories that are not sup-
plied or recommended by the manufacturer
- If the instrument is operated improperly or contrary to the manu-
facture's specifications
- if the instrument or the printed circuit board are modified by
third parties.
Unpacking
OS 1.0 power supply unit (for Wireless Controller (WiCo))
Adapter
Europe, Switzerland
Adapter
England

Drive

If a fault occurs, a safety circuit immediately switches off the mo-
tor permanently through a relay in the power board. A fault occurs
if the safe functioning of the instrument is compromised.
Fluctuations in mains voltage within the permitted tolerance range
have no effect on the quality of regulation and constancy of speed.
The speed is set using the front knob (B, see Fig. 1). During normal
operations the speed value on the display (C, see Fig. 1) corresponds
to the speed of the output shaft in revolutions per minute (rpm).
Adapter
USA, China
Adapter
Australia
22