Control Panel - dirna Bergstrom bycool green line compact 1.4 Manual Del Usuario

COMPACT 1.4
EN

Control panel

2
1.- On/off switch on /off the unit and functioning selection mode.
2.- Indicate the compressors functioning.
3.- Display: Screen where it shows the slected functioning and condition of the unit.
4.- Temperature selectors : To select the surrounding temperature and the blower speed
(this only in manual mode) , remote control programmation and Fahrenheit degrees.
• When you connect, the engine make leds control and you can read bd on the display
and the engine swith off.
Special display symbols (please see troubleshooting manual):
: Battery is low.
EO: Bad contact of probe cables or terminals or broken down probe.
Remote control
Remote control functions:
1
Switching on /off of equipment.
2
Blower speeds control.
3
Temperature control.
How to activate remote control:
In order to activate remote control, while equipment is switched off, push key
control panel until C
on in the remote control. You will have to do it within 30 seconds or else you will have to
repeat the whole operation.
How to deactivate remote control:
In order to deactivate remote control, push key
display. Once it stops flashing, push key
seconds or else you will have to repeat the whole operation.
ºC
ºF
3
TEMP
flashes on display. When it stops flashing, push the On/off key
8
Air conditioning for vehicles
4
1
2
of control panel until C , flashes on
on panel. You will have to do it within 30
ON/OFF
1
3
from