Safety Instructions For Maintenance And Fault Clearance On The Smartmaster - Kemper SmartMaster Manual De Uso

The connection of the welding power source (UVV VBG 15 § 43 Para 1) shall be
designed so that no stray welding current (fault current) flows through the protective
earth conductor of the SmartMaster. It is important to ensure that the welding current
return wire between the workpiece and welding machine has low resistance
and connections between the workpiece and SmartMaster are avoided.
2.5 Safety Instructions for Maintenance and
Fault Clearance on the SmartMaster
"Appropriate personal protective equipment should be worn for all work concerning
maintenance and fault clearance.
Before starting the actual maintenance work, the unit should be cleaned. For this, an
industrial vacuum cleaner for dust class "H" may be used."
Setting up, maintenance and repair work and troubleshooting must be performed
only when the device is switched off.
Always tighten bolt connections that have been loosened during repair work! If
specified, tighten the relevant bolts with a torque wrench.
In particular, clean dirt and cleaning products off connections and threaded couplings
before beginning maintenance / repair / care work.
WARNING
Skin contact with cutting fumes, etc. can cause skin irritation in
sensitive individuals!
Repair and maintenance work on the SmartMaster may only be
carried out by trained and authorized personnel while complying
with the safety rules and the applicable accident prevention
regulations!
Serious injury to the lungs and the respiratory tract is possible!
In order to avoid contact with and inhalation of dust, use
protective clothing, gloves and a powered air respirator!
The release of hazardous dusts during repair
and maintenance is to be avoided to ensure that persons not
charged with the task are not affected.
Art. No.: 150 2220
Technical changes and errors excepted.
KEMPER SmartMaster Operating Instructions - EN
- 39 - Rev.: 7
Latest update:
02/2015