Cleaning And Maintenance; Scope Of Delivery - HSM 104.3 Instrucciones De Servicio

5 Troubleshooting
Paper jam
You have fed in too much paper.
NOTICE! Do not press rocker switch alter-
nately forwards/backwards (
Cutting unit could be damaged.
• Press rocker switch
Pa per is pus hed out.
• Se pa ra te pa per stack.
• Press rocker switch
• Feed in pa per sheets.
Shredded material container full
NOTICE! Empty the cut material container
immediately, because if it is too full,
malfunctions can occur in the cutting
system.
• Switch equipment off. To do this tap
rocker switch
• Empty cut material container.
Shredded material container contact
interrupted
Document shredder switches off.
• Check whether shredded material
container is correctly inserted in bot-
tom frame.
For all other malfunctions, check whether the
motor was overloaded before contacting our
customer service. Let the shredder cool down
for approx. 15 – 20 mins. before using it again.
0802
- ).
.
.
.
HSM 104.3

6 Cleaning and maintenance

Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
must enter the equipment.
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer (Cross cut only):
• Spray special cutting block oil through paper
feed opening across the whole width of the
cutting system blades.
• Press automatic start stop control and run
cutting system forwards and backwards
( ) several times without feeding paper.
-
Paper dust and particles are shaken off.

7 Scope of delivery

• Paper shredder, ready for connection, in car-
ton packing
• 5 Bags for shredded material
• Special cutting block oil 50 ml (cross cut)
• Operating instructions
Acces so ries:
• Bag for shredded material
order No.: 1.661.995.050
• Special cutting block oil 250 ml
order No.: 1.235.997.403
9