Machine Components - HSM 104.3 Instrucciones De Servicio

HSM 104.3

3 Machine components

1 2 3 4 5
1 Cut material container
2 Feed opening
3 Automatic start stop control
4 Safety instructions
5 Rocker switch
: On
: Off, Reverse
8
4 Operation
Switching the paper shredder on
• Press rocker switch
Rocker switch locks in place.
Paper shredder is ready for op-
eration (standby).
Feed paper
• Insert the paper to be destroyed.
See "Technical data" for sheet
capacity.
Automatic start stop control
starts the cutting system auto-
matically.
Paper is pulled into cutting
system and shredded.
When the paper fee ding open-
ing is free again, the cut ting sy-
stem au to ma tical ly swit ches off
af ter app rox. 3 sec. and returns
to standby.
Shredding CDs and credit cards (see
"Proper Use")
CAUTION!
Depending on the type of material,
splinters could be produced when
shredding CDs. For this reason,
wear protective goggles.
Insert CD/credit card in centre of the feed
opening.
Swit ching paper shredder off
• Tap rocker switch
Switch returns to ze ro po si ti on.
.
.
0802