Adjusting The Position - JVC DLA-RS640 Guia De Inicio Rapido

Ways of Installation
This unit can be mounted sitting on its feet or ceiling mounted, and it supports front or rear projection.
Refer to the INSTRUCTIONS for the installation.
CAUTION
Special expertise and techniques are required for mounting this unit to the ceiling. Make sure that you get the
0
authorized dealer or a specialist to install it.
Be sure to fix the main unit and take the necessary actions to prevent it from falling off in order to avoid accidents
0
during an earthquake.
Projector sitting on its feet
.

Adjusting the Position

Adjusting the elevation angle of the projector
The height and inclination of the unit (0 to 5 mm) can be
adjusted by turning the feet.
Lift the unit and adjust the four feet.
Feet
.
Air Inlets
.
CAUTION
Leave a clearance of at least 10 mm from the bottom
0
surface of the unit to allow it to take in cool air.
4
Extend Contract
4 Locations
Ceiling Mount
.
Adjusting the position of the image
By using the lens shift feature of this unit, you can shift
the image upward/downward or to the left/right. Set it to
your preferred position.
Æ "Adjusting the Projection Screen" (P. 7)
■
Horizontal Position
Vertical Position: 0% (Center)
■
Vertical Position
Horizontal Position: 0 % (Center)
.
Up to about 34% of the
projected image
Up to about 80% of the
projected image