Stihl MM 55 Manual De Instrucciones página 17

English / USA
8
: Continue cranking until the engine
begins to fire. After no more than
five pulls, move the choke lever (8)
to the e position
: Continue cranking.
As soon as the engine runs:
: Blip the throttle trigger –
the engine returns to idling speed
Make sure carburetor is correctly
adjusted – tool must not move when
engine is idling!
Your unit is now ready for operation.
To shut down the engine:
: Move the slide control in the
direction of the arrow ( h ) to
STOP – $
16
If the engine does not start:
Choke lever
If you did not move the choke lever to e
quickly enough after the engine began to
fire, the combustion chamber has
flooded.
: Set the choke lever to e
: Move slide control, interlock lever
and throttle trigger to starting throttle
position.
: Start the engine by pulling the
starter rope firmly. 10 to 20 pulls
may be necessary.
If the engine still does not start:
10
: Move slide control to STOP.
: Pull off the spark plug boot (10).
: Unscrew and dry off the spark plug
: Open the throttle wide.
: Pull the starter rope several times to
clear the combustion chamber.
: Refit the spark plug.
: Connect the spark plug boot (press
it down firmly).
: Move slide control to #
: Set the choke lever to e – even if
the engine is cold.
: Now start the engine.
Fuel tank run until dry
: After refuelling, press fuel pump
bulb at least five times – even if the
bulb is already filled with fuel.
: Set the choke lever according to
engine temperature.
: Now start the engine.
MM 55, MM 55 C