Stihl MS 290 Manual De Instrucciones página 38

STOP
0
6
4
5
When engine begins to fire:
:
Press in decompression valve.
:
Move Master Control lever (4) to n
and continue cranking – as soon
as engine runs, immediately blip
the throttle trigger (5) –
the Master Control lever (4) will
move to the "Run" position # (6)
and the engine will settle down to
idling speed.
.
As the chain brake is still engaged,
the engine must be returned to
idling speed immediately – or the
engine and chain brake might
otherwise be damaged.
MS 290, 310, 390
: Pull the hand guard back toward
the front handle: =
The chain brake is now disengaged
– your saw is ready for operation.
Always disengage chain brake
before accelerating engine. High
revs with the chain brake engaged
(chain locked) will quickly damage
the powerhead and chain drive
(clutch, chain brake).
: Observe safety precautions.
: Always check operation of chain
lubrication before starting work.
English / USA
At very low outside temperatures:
:
Allow engine to warm up at part
throttle.
: Change over to winter operation if
necessary – see "Winter
Operation".
To shut down the engine:
:
Move Master Control lever to $.
If fuel tank has been run until dry
and then refueled:
:
Press in decompression valve.
:
Pull starter rope several times until
fuel line is primed.
:
Now start the engine.
37