Replacing Starter Rope And Rewind Spring - Stihl MS 290 Manual De Instrucciones

Ocultar thumbs Ver también para MS 290:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing Starter Rope
and Rewind Spring
1
1
1
:
Remove the screws (1).
:
Ease fan housing away from
crankcase and remove it sideways.
2
3
4
:
Use screwdriver or suitable pliers to
carefully remove spring clip (2) from
the starter post.
:
Carefully remove the rope rotor with
washer (3) and pawl (4).
The rewind spring may pop out and
uncoil during this operation.
MS 290, 310, 390
5
1
:
Ease the cap (5) out of the starter
grip.
:
Remove remaining rope from the
rotor and grip – make sure the
sleeve is not pushed out of the grip.
:
Tie a simple overhand knot in the
new rope ** and then thread it
through the top of the grip and the
rope bushing (6).
:
Refit the cap in the grip.
:
Thread the rope through the rotor
and secure it with a simple
overhand knot.
** see „Specifications"
6
English / USA
2
3
4
:
Coat rope rotor bearing bore with
non-resinous oil.
:
Push the rotor on to the starter post
and turn it back and forth to engage
the rewind spring's anchor loop.
:
Fit the pawl (1) in the rotor.
:
Fit the washer (2) on the starter
post.
:
Use a screwdriver or suitable pliers
to install spring clip (3) on the starter
post and engage it on the pawl's peg
– the spring clip must point
clockwise – see illustration.
45

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ms 310Ms 390

Tabla de contenido