Selecting The Source; Adjusting The Volume; Selecting The Sound Modes; Reinforcing The Bass Sound - JVC UX-H10 Manual De Instrucciones

Selecting the Source

To select the source, press TAPE,
TUNER/BAND, or CD.
• When you select TAPE or CD as
the source, playback does not start
automatically.
To operate the tuner (FM or AM), see pages 10 and 11.
To operate the CD player, see pages 12 – 14.
To operate the tape deck, see page 15.
To record on a tape, see pages 16 and 17.

Adjusting the Volume

You can adjust the volume level only while the unit is turned
on. The volume level can be adjusted between "VOL MIN,"
"VOL 1" – "VOL 39," and "VOL MAX."
• The volume level has no effect on recording.
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME –.
• When you press and hold either button, you
can change the volume level continuously.
To turn off the sound temporarily
On the remote control ONLY:
Press MUTING.
The volume level turn down and "MUTING"
starts flashing on the display.
To restore the sound, press MUTING again.
• Adjusting the volume level also cancels the muting.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on the headphones.
DO NOT turn off (standby) the unit with the volume
set to an extremely high level; Otherwise, the
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is in standby mode.
9

Selecting the Sound Modes

You can select one of the 4 sound modes.
TUNER
TAPE CD
/BAND
• This function also affects the sound from headphones.
• This function only affects the playback sound, and does not
affect your recording.
To select the sound modes, press SOUND/BASS
repeatedly.
• Each time you press the button, the sound mode
changes as follows:
POP:
CLASSIC: Enriched sound with fine treble and ample bass.
ROCK:
JAZZ:
FLAT:
VOLUME
When the sound mode is activated, the SOUND indicator
lights up on the display.

Reinforcing the Bass Sound

The richness and fullness of the bass sound is clearly
maintained regardless of how low you set the volume—Hyper
Bass Sound.
• This function also affects the sound from headphones.
• This function only affects the playback sound, and does not
MUTING
affect your recording.
To get the effect, press and hold SOUND/BASS
until "HBS ON" appears and the BASS indicator
lights up on the display.
• Each time you press and hold the button, the effect
alternates on ("HBS ON") and off ("HBS OFF").
To cancel the effect, press and hold SOUND/BASS again
until "HBS OFF" appears and the BASS indicator goes off.
POP CLASSIC ROCK
JAZZ
FLAT
(Canceled)
More presence in the vocals and midrange.
Powerful sound emphasizing treble and bass.
Accented lower frequencies for jazz-type music.
Equalizer effect is canceled.
SOUND
/BASS
SOUND
/BASS