Basic And Common Operations; Setting The Clock; Turning On The Power - JVC UX-H10 Manual De Instrucciones

Basic and Common Operations

Setting the Clock

Before operating the unit any further, first set the unit's clock.
When you plug in the power cord, "0:00" starts flashing on
the display.
You can set the clock when the unit is either turned on or in
standby mode.
• In the following procedure, the clock is set to 24-hour
system.
On the remote control ONLY:
1
When the unit is in standby mode,
press and hold PROGRAM until the
hour indication starts flashing.
• When the unit is on, press DISPLAY/CLOCK SET to
enter clock mode, then press and hold PROGRAM.
2
Press 4 or ¢ to adjust
the hour, then press
PROGRAM.
• When you press and hold 4 or
¢, the hour indication changes
continuously.
The minute indication start flashing.
3
Press 4 or ¢ to adjust
the minute, then press
PROGRAM.
• When you press and hold 4 or
¢, the minute indication changes
continuously.
The built-in clock starts.
• When you unplug the AC power cord or if a power failure
occurs
The clock is reset to "0:00" right away. If this happens, set the
clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
To select 12-hour or 24-hour clock system
You can select 12-hour or 24-hour for the clock system only
while the unit is in standby mode.
On the unit ONLY:
To change the clock setting, press
TIMER ON/OFF while holding down 7.
• Each time you press TIMER ON/OFF,
the clock change alternates between
12-hour and 24-hour system.
PROGRAM
To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY/CLOCK SET.
• Each time you press the button, the display
changes the clock indication and the normal
indication alternately.
To change the clock
Repeat steps 1 to 3 of the procedure "Setting the Clock."
PROGRAM

Turning On the Power

To turn on the unit, press
The STANDBY lamp on the unit goes off.
• When you press the source button—TAPE,
TUNER/BAND and CD, the unit automatically
turns on.
To turn off the unit (standby), press
again.
The STANDBY lamp on the unit lights red.
• "0:00" flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
PROGRAM
the display while the unit is on standby.
• A little power is always consumed even while the unit is in
standby mode.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "0:00" right away. If this happens, set the clock
again.
Continued
CD
CONTROL
TIMER ON/OFF
DISPLAY
/CLOCK SET
STANDBY/ON.
STANDBY/ON
STANDBY/ON
8