Routine Maintenance; Storage And Winterizing - Polaris 360 Manual Del Propietário

Routine Maintenance

Perform routine maintenance to prolong the life of your cleaner.
1
Empty the Bag
Empty the bag when it is half full, especially if the dirt load is mostly sand.
NOTE: It is easier to empty a dry bag. Remove the bag and let dry before emptying.
Alternate between two bags while drying, so the cleaning cycle is not interrupted.
2
Open the closure
and dump out the
debris.
2
Backwash the Pool Filter
Backwash your pool filter periodically. Always disconnect the Polaris
from the pool wall before cleaning or backwashing the pool filter. After cleaning or
backwashing, let the filtration system run for at least five minutes to flush out the
return lines before re-connecting the Polaris cleaner.
3

Storage and Winterizing

NOTE: Never store the cleaner in direct sunlight.
To store the cleaner for the winter:
1. Remove cleaner from the pool and drain all water to avoid freezing water damage
(freeze damage is not covered under the warranty).
2. Remove the UWF
pressure as you unscrew.
If necessary, use the UWF Removal Tool (part #10-102-00) available from your local
Polaris dealer.
from the pool wall using the Quick Disconnect. Use a pulling
®
1
Detatch the bag by releasing
the prongs. Remove the bag
tie collar from the feed hose.
cleaner
®
11