Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Fitting/Changing The Saw Blade - Parkside PSSA 20-Li A1 Traducción Del Manual De Instrucciones Original

CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
♦ Push the battery pack
♦ Switch off the charger
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Allow the battery pack
the appliance.
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
the status of the battery (see also main diagram).
The status will be shown on the battery display
LED as follows:
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PSSA 20-Li A1
flashes, this means
has overheated and
both
is
into the appliance.
for at least 15 minutes
to click into place in
and remove the
to check

Fitting/changing the saw blade

WARNING!
► Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury.
♦ Turn the quick-release chuck
stop and hold it in this position.
♦ Push the required saw blade
quick-release chuck
CAUTION!
► The teeth of the saw blade
downwards!
♦ Let go of the quick-release chuck
returns to its initial position. The saw blade
is now locked.
as far as the
into the
as far as the stop.
must point
so that it
GB │ IE │
21 ■