Electrical Connection; Important; Detergent Suction - Lavorwash MYSTIC Manual De Instrucciones

EN
When starting up for the first time or after a
long period out of use, connect the intake line
only for a few minutes so that any dirt is vented
from the delivery outlet.

ELECTRICAL CONNECTION

Check that the mains voltage is the same as
that of your machine, indicated on the techni-
cal data plate. Your electrical system must be
constructed by qualified technicians capable of
working in accordance with the requirements
of the regulations in force (earth connection,
fuses, differential security breaker, etc).
In case of failure to comply with one of the
regulations stated above, the manufacturer
declines all responsibility for the staff and
provides no warranty.
IMPORTANT: Regarding three-phase motors,
pay attention to the connection of the elec-
tric cable to the plug (see electric diagram).
START-UP
Switch on the machine by pressing the switch
and leave it to run for a few minutes to elimi-
nate any dirt and air bubbles from the water
circuit, then switch it off, connect the high pres-
sure line to the spray gun and fit the spray rod.
Make sure that the detergent regulator is in the
closed position.
When the machine is running again, check that
the jet is even; otherwise, clean the nozzle to
remove any dirt. Wait a few seconds for the op-
erating pressure to be reached, then operate
the gun for two or three short bursts.
> LANCE ASSEMBLY
To fit the lance to the gun, it is sufficient to in-
sert the threaded end of the lance into the hole
on the gun ; then screw the lance as shown by
the arrow until the connection is tight.
> Spray gun accessories
•
Caution: Never use the spray gun
without an accessory!
Use of the lance
The high-pressure cleaner is supplied with 4
different nozzle types:
Use of the machine in low pressure:
- Low-pressure nozzle (fig. 3A, CHEMICAL"-
BLACK):
for operating with detergent or cleaning with
negligible pressure, the mixing of the detergent
with the water is automatic at the water passage
(see "detergent collection" section).
Use of the machine in high pressure:
- 0° nozzle: straight stream (fig. 3B),
- 15° nozzle: flat spray (fig. 3C)
- 40° nozzle: flat spray (fig. 3D)
These jets allows to remove the hardest dirt;
the machine will work at the max pressure.
>

DETERGENT SUCTION

Fill up the detergent tank (not included) with
the suggested products, suitable for the kind of
washing to be carried out.
•
CAUTION: Make use only of liquid deter-
gent, do not absolutely use acid or too
much alkaline products. We suggest you
to make use of our products, which have
been studied for the use with washer ma-
chines.
•
CAUTION: For proper use of the tank, do
not introduce flammable or chemically
harsh substances.
The adjusting head allow you to select water
jet at low and high pressure. Pressure can be
adjusted by acting on nozzle knob: means low
pressure, means high pressure. The selection of
low or high pressure shall be carried out with
gun in closed position. The detergent suction
is automatic when the adjusting head of the
lance is positioned for low pressure operation.
When you start the machine, the mixing of the
detergent with the water is automatic at the
water passage.
> APPLIANCES PROVIDED WITH THERMAL
VALVE (OPTIONAL)
22