Drill Safety Safety Warnings - SPARKY HeavyDuty BR 102E Instrucciones De Uso

ing power tools. Such preventive safety
measures reduce the risk of starting the
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tool's op-
eration. If damaged, have the power tool
repaired before use. Many accidents are
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for op-
erations different from those intended could
5) Service
a) Have your power tool serviced by a
tical replacement parts. This will ensure
that the safety of the power tool is main-
Drill safety warnings
During operation provide eye protec-
ing particles. Wear goggles.
Take protective measures against inha-
lation of dust. Some materials can contain
toxic ingredients. Wear a dust mask and
Hold the power tool by insulated gripping
surfaces only, when performing an op-
eration where the cutting accessory may
contact hidden wiring or its own cord. Cut-
ting accessory contacting a "live" wire may
make exposed metal parts of the power tool
"live" and could give the operator an electric
Original instructions
tos. Asbestos is considered carcinogenic.
WARNING: Before connecting a tool
to a power source be sure that the voltage
nameplate of the tool.
injury to the user, as well as damage to the
tool.
the nameplate rating is harmful to the motor.
potential overheating.
must ensure that it has the right ampere rating
for your power tool and it is in safe electrical
condition.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
determine if utility lines are hidden in the work
area or call the local utility company for as-
-
sistance. Contact with electric lines can lead
can lead to explosion. Penetrating a water
line causes property damage or may cause
electric shock.
area of the power tool.
ble. Do not touch the damaged cable and pull
-
the mains plug when the cable is damaged
while operating. Damaged cables increase
the risk of electric shock.
sure no one is below when using the tool in
high locations.
-
whenever possible.
machine or upon jamming the drill bit.
during operation and immediately after that;
they may be extremely hot. You may get seri-
ous burns.
particularly dangerous. Dust from light alloys
can burn or explode.
-
-
5
EN