Know Your Product; Operation - SPARKY HeavyDuty BR 102E Instrucciones De Uso

never be left around the work area.
it down.
purpose. Any use other than those mentioned
in this Manual will be considered a case of
misuse. The user and not the manufacturer
shall be liable for any damage or injury result-
ing from such cases of misuse.
the safety warnings, the assembly and op-
eration instructions in this booklet. All persons
who use and service the machine have to be
acquainted with these Original Instructions
and must be informed about its potential haz-
ards. Children and frail people must not use
this tool. Children should be supervised at all
times if they are in the area in which the tool is
being used. It is also imperative that you ob-
serve the accident prevention regulations in
force in your area. The same applies for gen-
eral rules of occupational health and safety.
changes made to the tool nor for any damage
resulting from such changes.
rainy weather, or in moist environment (after
liquids and gases. The working place should
be well lit.

Know your product

Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Securing screw
4. Ventilation slots
5. Belt clip
6. Reversing button
8. Lock-on button

Operation

This power tool is supplied from single-phase al-
ternating current mains only. It is double insulat-
ed according to EN 60745-1 and IEC 60745 and
can be connected to grounded or not grounded
6
EN
sockets. This power tool is radio suppressed in
compliance with EMC Directive.
This power tool is designed for drilling in steel,
wood, plastics, etc.
This power tool is not designed for drilling in
concrete and other brittle materials.
PRIOR TO INITIAL OPERATION
sponds to the value indicated on the name
plate with technical data of the tool.
ger. The power tool must be connected to the
power supply socket only when this trigger is
a receptacle while the trigger is in the ON
position, the power tool will start operating
immediately, which could cause a serious ac-
cident.
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
er source, use as short as practicable exten-
sion cord with proper cross-section.
SWITCHING ON - SWITCHING OFF
Brief activation
Continuous use
pressed position lock it by button 8.
and release it immediately.
SMOOTH ELECTRONIC RPM CON-
TROL
low rotation speed, further pressing the switch
results in a smooth increase of the rpm to maxi-
mum when reaching the extreme position.
REVERSING
The power tool is equipped with reversing but-
ton 6. Press the button 6 in position <= (side A)
-
-
-
BR 102E