Impact Drill Safety Warnings; Know Your Product; Operation; Prior To Initial Operation - SPARKY BUR 131E Instrucciones De Uso Originales

ments, changing accessories, or storing
power tools. Such preventive safety meas-
ures reduce the risk of starting the power tool
accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) maintain power tools. check for misalign-
ment or binding of moving parts, break-
age of parts and any other condition that
may affect the power tool's operation. if
damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these instruc-
tions, taking into account the working
conditions and the work to be performed.
Use of the power tool for operations different
from those intended could result in a hazard-
ous situation.
5. SERvicE
a) Have your power tool serviced by a quali-
fied repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
IV - Impact drill safety
warnings
The small chip and particles separated while op-
erating the power tool, as well touching its moving
parts could cause severe physical injuries, and
noise loading from continuous operation could
damage the operator's hearing if the Safety In-
structions and the below-mentioned rules are not
observed.
▪ During operation provide eye protection to
prevent eyes from exposure to flying particles.
Wear goggles.
▪ Wear hearing protection when operating the
tool for extended periods.
▪ Always tie long hair behind and do not wear
loose clothing while working.
▪ Always keep the cord away from the working
area of the power tool.
Original instructions
▪ Always use the auxiliary handle.
▪ Always search for a secure and stable position
of your body.
▪ Fix the machined piece in vice or in another
appropriate way.
▪ Watch out for the initial torque reaction of the
drill, especially when drill bit is tight.
▪ Always switch off the power tool and unplug
the machine prior to any adjustment, repair,
maintenance or in case of mains drop out.
▪ The power tool must not be used outdoors in
rainy weather, or in moist environment (after
rain) or in close vicinity with easily flammable
liquids and gases. The working place should
be well lit.
V - Know your product
1. Securing screw
2. Chuck
3. Place for spindle fixing
4. Drill journal
5. Operation mode selector switch
6. Ventilation slots
7. Depth gauge
8. Auxiliary handle
9. Reversing switch
1 0. E lectronic regulator of rotation speed
1 1. ON/OFF switch
1 2. L ock-on button
VI - Operation
This power tool is supplied from single-phase al-
ternating current mains only. It is double insulated
according to EN 60745, IEC 60745 and can be
connected to grounded or not grounded sockets.
This power tool is radio suppressed in compliance
with EMC Directive 2004/108/EC.
This power tool is designed for impact drilling in
steel, wood, plastics, etc. The provided impact-
rotary operation mode ensures drilling openings
in concrete, stone, masonry and various brittle
materials.

pRiOR tO initial OpERatiOn

WaRNiNg: Make sure the power
supply voltage corresponds to the value
indicated on the name plate with technical data
of the appliance.
5
EN