Electric Brake - Genesis GCID18K Manual Del Operario

• Do not use force when inserting the battery pack. If the battery does not slide in easily, it is not being inserted
correctly.
• To remove the battery pack, withdraw it from the tool while depressing the tabs (1) on both sides of the battery
pack.
TRIGGER SWITCH ACTION
• Turn the driver on by depressing the trigger switch (3-FIG 1).
• Depressing the switch further will produce more speed and torque.
• Use the reversing switch (4-FIG 1) to change the direction of rotation of the driver.
• The reversing switch has three positions: Forward, Reverse, and Off (middle).
• Always check the rotation before beginning your work.
LED WORK LIGHT
Your tool has a built-in LED work light to illuminate the work area. When you turn on the tool, the work light will
automatically turn on.

ELECTRIC BRAKE

This driver is equipped with an electric brake. The electric brake provides you with another element of control
during various operations. If the tool consistently fails to quickly stop after trigger switch release, have a qualified
serviceman examine the tool.
1/4" HEX CHUCK
• Your driver is equipped with a tool-less 1/4" Hex Chuck, so you can quickly change bits with no extra tools
required.
• Remove battery pack or place the Forward/Reverse Switch in the center (OFF) position.
• To insert or change bits, pull the chuck locking sleeve (7-FIG 1) away from the tool. Hold it with one hand while
inserting the bit with the other hand. Release the locking sleeve to lock the bit in place.
• Always make sure that bit is seated firmly by pulling on the bit. Never attempt to operate a bit that is wobbly,
unstable, or broken.
• To remove the bit, pull the chuck locking sleeve away from the tool, remove the bit and release the sleeve.
NOTE:
Only use Impact-Quality Bits with a locking groove.
APPLICATION
WARNING:
WARNING:
tightening fasteners to specified torques.
GENERAL SCREWDRIVING
1. Clamp your workpiece.
2. Drill pilot holes for larger screws or when driving screws into hardwoods.
3. Exert enough pressure to start the screw and keep it turning. Do not force the screw. Let the tool do the work.
4. Use a speed that will not strip the screw head or break the screw. Maintain your balance.
The Impact Driver is NOT intended to be used as a drill.
The Impact Driver is NOT a torque wrench. Do not use this tool for
9