Connecting The Trimmer Unit To The Pole - Makita EN4950H Instrucciones De Manejo

CONNECTING THE TRIMMER UNIT TO THE POLE

WARNING:
unit to the pole.
1. Remove the cap from the shaft.
2. Loosen the M5 x 16 screw and M5 x 25 bolt.
3. Insert shaft into the cover.
and the M5 x 25 bolt.
ATTACHING THE HANDLE
Fix the loop handle on the shaft as shown.
arrows.
USING THE SHOULDER STRAP (Optional accessory)
How to wear the shoulder strap
Wear the shoulder strap over the left shoulder.
Detachment
machine from you.
Be extremely careful to maintain control of the machine at this time. Do not allow
Drive axle
10
M5 x 25 bolt
Cover
Shaft
M5 x 16 screw
Cap
Shoulder strap
Wear over left
shoulder