Connecting The Trimmer Unit To The Pole - Makita EN5950SH Instrucciones De Manejo

CONNECTING THE TRIMMER UNIT TO THE POLE

WARNING:
• Make sure that the engine is turned off, and remove the spark plug cap before
assembling the pole hedge trimmer.
• Wear protective gloves!
• Secure cutting blades with the blade cover provided when connecting the trimmer
unit to the pole.
1. Remove the cap from the shaft.
2. Loosen the M5 x 12 screw and M5 x 25 bolt.
3. Insert shaft into gear case.
NOTE: Make sure that the shaft is completely inserted into the gear case
(approx. 44 mm/1.73").
If you are having trouble inserting the shaft, manually rotate the drive axle a
little and try again.
4. Make sure that the shaft is properly inserted and then tighten the M5 x 12 screw
and the M5 x 25 bolt.
44 mm
Shaft
10
Drive axle
M5 x 12 screw
M5 x 25 bolt
Cap