Manual Buttonhole; To Sew - Sears Kenmore 385.16528000 Manual De Instrucciones

Manual Buttonhole
_1_ Stitch selector: _] (BH)
(_) Stitch width: 3 to 6.5
(_) Stitch length: Blue zone
(_ Needle thread tension: 2 to 6
Presser foot B: Buttonhole foot
• To sew
If the diameter of the button is more than 1.0"
(2.5 cm), a buttonhole must be made manually as
follows:
[] Turn the handwheel toward you to raise the needle to
its highest position. Raise the presser foot lifter.
[] Set the stitch at" D" by turning the stitch selector.
If the stitch is already on at "_]" reset the machine in
accordance with the instructions on page 78.
[] Attach the buttonhole foot [ B] .
[] Pull the buttonhole lever downward as far as it will go.
[] Lower the needle into the garment where the buttonhole
is to start, and lower the foot.
[] Sew the front bartack and left row, then stop the
machine after sewing the desired total length of
buttonhole.
[] Pull the buttonhole lever toward you.
S
/-
/-
l
_ WEDTH
_ LENGTH (_
® ®
i
i
J
J
[] Sew the back bartack and right row, then stop the
machine at the starting point.
"5 cut the opening and to reset for sewing the next
buttonhole, refer to the instructions on page 78.
[]
J
J
84