salmson SIRIUX Serie Instalacion Y Puesta En Servicio página 62

English
5.2 Technical data
Siriux-O
Emission
sound-pressure level
EMC (electromagnetic
compatibility)
Emitted interference
Interference resistance
Residual current ΔI
1)
Standard version
2)
Special version or supplementary equipment (additional charge)
3)
See following warning
CAUTION! Risk of injury and damage to property!
Non-approved fluids can damage the pump and also cause injury.
Comply strictly with the relevant safety data sheets and manufacturer's data!
3)
• Observe the specifications of the manufacturer regarding the mixing ratios.
3)
• Additives are to be mixed to the fluid on the pressure side of the pump, even
if this is contrary to the recommendations of the additive manufacturer!
CAUTION! Risk of damage to property!
When changing, refilling or replenishing the fluid with additives, there is a risk of
material damage caused by the increasing concentration of chemical substances.
The pump is to be flushed separately for a sufficient amount of time to ensure the
old fluid has been completely removed from the interior of the pump.
The pump must be disconnected for pressure cycle flushing. Chemical flush-
ing measures are unsuitable for the pump, in this case the pump must be
removed from the system for the duration of cleaning.
56
The material selection of the pumps corresponds to the
state of the art with regard to the guidelines of the German
Federal Environmental Agency (UBA) which are referred to
in the Drinking Water Ordinance (TrinkwV).
Chemical disinfectants can result in damage to material.
< 54 dB(A)
(depending on the pump type)
General EMC: EN 61800-3
EN 61000-6-3
EN 61000-6-2
≤ 3,5 mA (see also chapter 7.2)
Pompes Salmson 05/2015